Base Gaskets To suit Enots Dome Glass
Part Nr 62-462 Enots dome oil sight glass base Gasket
This gasket sits under the base of an Enots dome oil sight glass.
There is a 2mm thick neoprene impregnated cork gasket and a 3mm thick gasket in the kit to cope with various thread lengths on the pumps over the decades . In unusual cases where a 4mm thick gasket is required consider purchasing two kits and place a 2mm gasket on top of another 2 mm gasket to achieve 4mm . Please read the secondary information below regarding estimating the thickness required.
Secondary information
Clean the threads thoroughly and apply a spot of thread grease to the threads.&edsp;&edsp;When you estimate which thickness of gasket to fit imagine which thickness it has to be so that, after tightening and an initial compression after Tweaking of say 18%, the retaining ring will still not be fully screwed down to the base, (IE. Some thread can still be seen to allow further tweaking in future).
After tightening leave alone for two hours then tweak tighten. After ten to twenty-four hours have elapsed tweak tighten again. For best long term results try to do the installation when the ambient temperature and the temperature of the metal on the motorcycle&edsp;&edsp;is between 15 Celsius and 25 Celsius